Page 1 of 1

Wanted: V8 single rail gear shifter

PostPosted: Fri Dec 12, 2008 1:21 am
by MrSpeed
Ive made up something that will get me out of trouble for now, but need the correct V8 shifter.

Re: Wanted: V8 single rail gear shifter

PostPosted: Wed Jan 07, 2009 5:15 am
by toecutter
Well this depends on what you have and what you want. i swapped a p76 shifter for a holden shifter on my single rail, so it would be 4 inches to the left from stock.

This was lucky, because i had both on the shelf and could compare.

I would have tried a chrysler one as well, but didnt have one handy.

good luck.

Re: Wanted: V8 single rail gear shifter

PostPosted: Tue Feb 10, 2009 2:22 pm
by MrSpeed
toecutter wrote:Well this depends on what you have and what you want. i swapped a p76 shifter for a holden shifter on my single rail, so it would be 4 inches to the left from stock.

This was lucky, because i had both on the shelf and could compare.

I would have tried a chrysler one as well, but didnt have one handy.

good luck.


I gave up looking and made a 6 cylinder stick into a V8 stick, also added one of those alluminium securing nut to replace the nylon one,so its in there for good.

cheers

simon.