Modifying the Abbyshot MFP badge

Discuss items from the film, making replicas, and so on.

Modifying the Abbyshot MFP badge

Postby HUMVEE Driver » Fri Mar 04, 2011 7:56 pm

Here's a quick heads-up about an option for the Abbyshot MFP badge.

I wore the badge on the outside of my right boot, like in the movie. But all that is there to hold it on is that little pin. I found that it was very easy to accidently brush my leg against just about anything and dislodge the pin. Not fun if you lose a $40 dollar badge like that. Eventually, the pin broke off. So, I soldered four nickel-plated rivets to the back of the badge (the badge is copper) and just rivetted it to my boot. Now it's on there rock solid.

Just a helpful tip from HUMVEE Driver!
"I'll see you on the road!"
http://www.madmaxmodels.com
User avatar
HUMVEE Driver
 
Posts: 1316
Joined: Sun Oct 17, 1999 4:18 am
Location: Detroit area, USA

Re: Modifying the Abbyshot MFP badge

Postby RoadWarrior101 » Sat Mar 05, 2011 7:42 am

Thanks for sharing HUMVEE! ;)
RoadWarrior101
 
Posts: 34
Joined: Sun Jul 04, 2010 9:24 am

Re: Modifying the Abbyshot MFP badge

Postby Max Replica » Sat Mar 05, 2011 2:18 pm

Yeah, the pin on the Abbyshot badge sucks. I've nearly lost both of my badges because of it.
Soldering and riveting is a great permanent solution.
But if you're not up to soldering, you can do what I did and tear the original pin off, and then use a product like JB KWIK to glue a couple of clutchback pins onto the back of the badge. I did this for both my boot and jacket badge.
The Replica Warrior
http://wastelandweekend.com/
User avatar
Max Replica
 
Posts: 660
Joined: Wed Oct 24, 2007 9:28 am
Location: Los Angeles


Return to Costumes and Props

Who is online

Users browsing this forum: No registered users and 2 guests


cron