Question about the Springee Beak dude on NUX dash

Discuss the facts, the rumours, plot ideas, merchandising ideas, whatever...

Question about the Springee Beak dude on NUX dash

Postby brokenhill » Mon Jun 08, 2015 3:22 pm

So my oldest Daughter wants me to make her one for her Jeep Dash. Any thoughts on the parts that went into it?the bottom of the beak looks like motorcycle handle bar break calipers.
Anything you guys can Help with I'd appreciate
brokenhill
 
Posts: 157
Joined: Tue Feb 18, 2003 3:35 am
Location: USA

Re: Question about the Springee Beak dude on NUX dash

Postby Ishnox » Tue Jun 09, 2015 7:44 am

Image

I was going to try and make a gif, but some good soul already has and did a better job than I could. It's not bad as far as a reference goes. It comes from here, and you can see a few more up-close stills of it there, as well as a discussion on what it's made of.
There's also this artist's version, which looks very similar to the real thing. Give those links a go, they'll probably do better than anything I could try to pick out just from pictures.
I Am.

Don't Doubt Me.
User avatar
Ishnox
 
Posts: 8
Joined: Sun Jun 07, 2015 9:21 pm
Location: Bullet Farm

Re: Question about the Springee Beak dude on NUX dash

Postby Ishnox » Tue Jun 09, 2015 7:46 am

Here is how the previously linked artist made that bobblehead.
I Am.

Don't Doubt Me.
User avatar
Ishnox
 
Posts: 8
Joined: Sun Jun 07, 2015 9:21 pm
Location: Bullet Farm


Return to Mad Max 4 - Fury Road

Who is online

Users browsing this forum: No registered users and 3 guests